NCS Pearson 5000i, Руководство по установке

Страница: 40 / 54

6. Complete installation of the 5 BNC/15-pin DIN cable - from the bulkhead (for the
monitor) to the back of the computer.
•
One end (5 BNC end) is already attached to the bulkhead.
•
Connect the other end (15-pin DIN) to the back of the computer.
Connect this cable to the 15-pin connector on the video card in the first expansion
slot. Do not connect the cable to the 15-pint connector on the system board.
7. Complete installation of the 50-pin high density ribbon cable - the Camera Controller
board to the Hobbes interface connector on the computer.
•
One end of this cable is already connected to the scanner's Camera Controller board
at J1.
•
Connect the other end (free end) to the external connector for the scanner interface
(Hobbes) card (P2) on the computer.
8. Complete installation of one 9-pin D cable - the Scanner Controller main board to the
Com1 port on the back of the computer.
•
One end of this cable is already attached to the scanner's Scanner Controller main
board at J9.
•
Connect the other end (free end) to the Com1 port on the back of the computer.
Once all computer cabling connections have been made, set down the computer flat on the shelf,
coil any extra cabling under the computer shelf, and close the rear panels.
Monitor and Keyboard
Place the monitor on top of the scanner on the right-hand side (Figure 3-3). Install the keyboard
using the four pressure sensitive adhesive backed velcro pads that were shipped with the
keyboard. Peel off the paper backing on one side of the pads and affix to the four corners of the
keyboard. Peel off the paper backing from the other side and affix the keyboard to the angled
shelf on the upper left-hand side of the scanner. Place the mouse and mouse pad on the flat
surface just to the right of the keyboard (Figure 3-3).
To cable the monitor and the keyboard to the computer, do the following.
Monitor{ XE "Network installation:Monitor" }
1. Attach the power cord.
•
Plug the female end of the power cord into the back of the monitor.
•
Plug the male end into a nearby AC power outlet or a power strip.
2. Ensure that the monitor cable is properly connected. (Refer to Step 7 under “Cabling.”)
3. Complete installation of the 5 BNC cable - from the bulkhead to the back of the monitor.
•
Connect one end of this cable to the bulkhead. Install the cable according to the
colors labeled on the bulkhead.
•
Connect the other end (15-pin) to the back of the monitor.
Page 28 5000 i Scanner Installation Guide