Installation
The installation
{
XE "Scanner installation:Sequence of events"
}
sequence for the 5000
i
scanner
includes:
1.
Check the installation site
{
XE "Check the installation site"
}{
XE "Installation site:verify
readiness"
}
to verify that it is ready for setup and installation of the 5000
i
scanner with its
computer, monitor, keyboard, and mouse.
2.
Install the scanner.
3.
Install the computer, monitor, keyboard, mouse, and furniture.
4.
Check the voltages.
5.
Connect the network cable (optional)s.
6.
Configure the internet network addresses and test the network (optional).
7.
Verify that all software has been pre-loaded.
8.
Run the
Scanner Exerciser
Utility
to check the following:
−
Sheet feeding (in the
Scan Sheets
menu).
−
Selecting and printing (in the
Scan Options
menu).
−
Color selection (under
Configuration
).
9.
Run the
Scanner Exerciser Utility
to check alignment (under Check Alignment).
10.
Run the
Camera Setup
utility to check and adjust camera/mirror alignment and focus.
11.
Run the
Normalize and Calibrate
Utility
on the scanner.
12.
Run sample application using Image ScanTool.
13.
Power off the system.
The above installation sequence and the following instructions serve as a typical step-by-step
guide only. They may not exactly fit your setup.
Checking the Installation Site
Before you begin installing the 5000
i
scanner, verify
{
XE "Scanner installation:Check the site"
}
the
following site conditions:
•
Check the physical dimensions
{
XE "Installation site checkout:Physical requirements"
}{
XE
"Physical dimensions required"
}
of the selected site to ensure adequate space.
−
The 5000
i
scanner is 57.5 inches high, 48 inches wide, and 29 inches deep.
−
If the scanner is near a wall, be sure to leave approximately 24 inches of space between
the scanner and the wall. This space is required so that an operator can open the rear
panel doors.
•
Check that the site selected for the scanner meets all power
{
XE "Installation site
checkout:Power requirements"
}{
XE "Power requirements"
}
and environmental
requirements
{
XE "Environmental requirements"
}{
XE "Installation site
checkout:Environmental requirements"
}
.
Chapter 2. Scanner Installation
Page 7
Содержание 5000i
