NCS Pearson 5000i, Руководство по установке

Страница: 37 / 54

Network Installation{ XE "Scanner, 5000 i: Network
configuration" }
The 5000 i scanner in a network configuration requires an NCS Pearson-supplied computer,
monitor, keyboard, mouse and required networking equipment. An optional printer may also be
installed.
tiger001
Figure 3 – 3: Network Connection
Computer
This section discusses installation and internal cabling for the computer { XE "Network
installation:Computer" } in a network configuration.
Installation
Before installing the computer in the scanner, do the following.
1. Use your fingers (or a screwdriver) to remove the screw (knurled knob) at the rear of the
computer (center-top) and lift off the cover. Some models have green plastic covered
screws, and some have two screws. Some models have green plastic covered screws, and
some have two screws.
CAUTION:
Use ESD precautions (including a grounded wrist strap) for
steps 2, 3, and 4.
2. Make sure that the scanner interface cards and all ribbon cables are fully seated.
3. Remove the Catgut board from its separate packaging and do the following:
•
Ensure that the three 40-pin DIP and one 40-pin SIP headers that connect the Catgut
II board to the Catgut I board are fully seated.
Chapter 3. Computer and Peripherals Installation Page 25