58
NH 2001M
NBase Communications
Port Monitoring Commands
set-mon-port
Set monitoring port
monitor
Set port to be monitored
stop-mon
End port monitoring
get-nv-mon
Retrieve port monitoring information stored in NVRAM
save-mon
Save current port monitoring information into NVRAM
clear-nv-mon
Clear previously stored port monitoring information
Port Configuration Commands
get-port-cfg
Display the configuration of all ports
set-port-dplex
Set the port mode: full or half duplex
set-speed-sel
Set the port speed : 10Mbps, 100Mbps or Asense
set-port-state
Enable or disable a port when Spanning Tree
algorithm is not running
Switching Statistics Commands
clr-cnt
Clear the switch Ethernet and bridging counters
get-eth-cnt
Get the Ethernet counters per port
get-colls-cnt
Get the collision distribution counters per port
get-rmon-cnt
Get the Ethernet RMON counters per port
get-sdist-cnt
Get packet size distribution counters per port
get-mgm-brcnt
Get the switching counters of the mgmt port
Spanning Tree Commands
get-stp
Display the Spanning Tree session state
set-stp
Enable/Disable Spanning Tree - for the next session
get-st-bcfg
Retrieve the Spanning Tree Bridge parameters
get-st-pcfg
Retrieve the Spanning Tree port parameter table
get-st-syscfg
Retrieve the Spanning Tree System Ports configuration
set-br-prio
Set the Spanning Tree bridge priority
set-br-maxage
Set the Spanning Tree bridge MaxAge
set-br-hellot
Set the Spanning Tree bridge HelloTime
set-br-fwdel
Set the Spanning Tree bridge Forward Delay
set-prt-prio
Set the Spanning Tree port priority
set-prt-enb
Set the Spanning Tree port enable/disable
set-prt-pcost
Set the Spanning Tree port path cost
AI2001SB.QXD 4/5/98 11:27 AM Page 58
