Navman 8084, Инструкция по установке и эксплуатации

Страница: 71 / 116

NAVMAN 8120/8084 Installation and Operation Manual 71
18-11-4 Adjusting the boundaries of a radar
guard zone
To adjust the boundaries and change the area
that is covered by a radar guard zone:
1 From the radar window, press MENU then
select Guard Zone.
2 Select Zone then 1 (radar guard zone 1) or
2 (radar guard zone 2).
3 Select Adjust to display the current
boundaries of that radar guard zone. The
following information is also shown in the
top left corner:
• Guard Zone The number shows the
radar guard zone that is selected.
• Sector or Circular The shape of the
radar guard zone.
• INR The distance between the inner
boundary and your boat.
• OUR The distance between the outer
boundary and your boat.
• WDT The angular width of the radar
guard zone (in degrees).
• BRG The bearing of a line drawn from
your boat through the centre of the
radar guard zone (in degrees).
4 Use < and > to select the parameter to
change.
5 Then use ^ and v to change the parameter.
18-11-5 Adjusting the sensitivity of the
alarm
You can set the sensitivity of the alarm for the
radar guard zones, to define the size of the
target that will trigger the alarm. The size of
target is shown as a percentage.
100% is maximum sensitivity, meaning that
very small targets will trigger the guard zone
alarm. 0% is minimum sensitivity, meaning
that only very large targets will trigger the
alarm.
The same sensitivity setting is applied to
both of the radar guard zones if both are
turned on.
To set the alarm:
1 From the radar window, press MENU then
select Guard Zone.
2 Select Zone then select 1 (radar guard
zone 1) or 2 (radar guard zone 2).
3 Select Alarm sensitivity then use < and >
to decrease or increase the setting.