Navini Networks, Inc.
Ripwave MX Surfer Modem User Guide
5
English_Surfer_User_Guide_2007-05-04_40-00444-00Ra(6.X)
Regulatory Information
FCC Notice
CAUTION
: This device is a Radio Frequency transmitter. It is required to comply with FCC RF
exposure requirements for transmitting devices. For all Surfer Modems, a minimum separation distance of
8 inches (20 cm) or more must be maintained between the antenna and all persons during device
operations to ensure compliance with the FCC’s rules for Radio Frequency Exposure. If this minimum
distance cannot be maintained, exposure to RF levels that exceed the FCC’s limits may result.
FCC Compliance and Advisory Statement
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part
15 of the FCC rules. The operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
If this equipment causes interference to radio or television reception, which can be determined by turning the
equipment off and on, the user should try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and the receiver.
3. Connect the equipment to an outlet on a circuit that is different from the one to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV technician for additional suggestions.
This product has been tested and found to be safe in accordance with the Australian Standard for Human
Exposure to Radiation where the user or other parties are 20 cm or more from the aerial. If the antenna is closer
than 20 cm from the user, Australian safety conditions are violated.
INFORMATION TO USER
This device has been authorized as a radio frequency transmitter under the appropriate rules of the Federal
Communications Commission. Any changes or modifications not expressly approved by Navini Networks, Inc.
could void the user’s authority to operate the equipment.
INFORMATION REGARDING ANTENNAS
This device has three embedded antennas: one embedded dipole with approximately 2 dBi gain and two patch
antennas, one on each side of the device. Each patch antenna has approximately 6 dBi gain. The overall antenna
gain is 9 dBi.
This product has been tested and met all the applicable requirement of the R&TTE directive (99/5/EC).
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
