![background image](http://html2.mh-extra.com/html/nautilus/be-strong-commercial-r916/be-strong-commercial-r916_assembly-manual_3519601014.webp)
with the corresponding side of the F.I.S.P. dongle.
f the ribbon
ack of the C5X
console/controller. Plug the F.I.S.P. into the back of the console/controller.
NOTE: IF F
ONG WAY.
MAKE SURE IT IS ORIENTED CORRECTLY.
tly. If the F.I.S.P. LED still does not turn on, replace the F.I.S.P. programming ribbon cable (p/n
27834).
2. Connect one side of the F.I.S.P. programming ribbon cable (doesn’t matter which side) to the F.I.S.P.
dongle. Match the keyed side of the cable connector
Keyed slot
3. Look at the end of the F.I.S.P. programming ribbon cable and locate the keyed side. Remove the plastic
access plate on non-TMs or the steel plate on the T9.xx or TC9.xx and match the keyed side o
cable connector with the corresponding side of the 10-pin connector on the b
ORCED, THE CONNECTOR CAN FIT THE WR
4. There is one Light Emitting Diode (LED) that can turn three different colors, depending on the
programming status. Power ON the console/controller. Verify that the LED on the F.I.S.P. turns YELLOW
for a few seconds and then starts to blink. If the LED does not turn on, verify that the connector is plugged
in correc
F.I.S.P. LED
Note: shown is a C40 non-
treadmill console. The
connection for a C51/C52
controller will look similar.
10-Pin connector
located here
14