perform
ftware upgrades on all C51/52 consoles / controllers using a FISP Dongle.
ed:
SOFTWARE UPGRADE PROGRAMMING INSTRUCTIONS
TREAD and NON-TREAD C51 and C52 CONSOLE/CONTROLLERS –
USING THE FIELD IN-SYSTEM PROGRAMMER (FISP) DONGLE
Occasionally it will be necessary to reprogram the console if there has been a software revision. Use these instructions to
so
Parts need
e
ce of XX when ordering. For example
Kit, FISP
•
P/N 41375-7XX) programmed with the correct C51 program version (T9.14, EV9.16 etc). The version number should b
used in pla
, if you need revision 3, then you would order p/n 41375-703. The kit
includes:
e
ce of XX when ordering. For example
OR
•
P/N 41376-7XX) programmed with the correct C52 program version (T9.16, TC9.16 etc). The version number should b
used in pla
, if you need revision 3, then you would order p/n 41376-703. The kit
includes:
•
are available separate from the kit - use p/n 27834.
•
1 x Programming Instructions (this document)
arts needed:
•
1 x F.I.S.P.
1 x F.I.S.P. programming cable
Note: Replacement F.I.S.P. programming cables
P
it, F.I.S.P.
. Program the console
t goes into the idle stage and powers down. If the unit is a treadmill,
turn the circuit breaker switch to OFF.
K
F.I.S.P.
Programming
ribbon cable
F.I.S.P
A
1. Power OFF the console/controller. If the unit has a power supply, disconnect the power supply. If the unit is
battery operated, make sure that the uni
13
