Nautel NX5 AM, Руководство по эксплуатации и техническому обслуживанию

Страница: 112 / 220

NX5 OPERATION & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
PAGE 3.2.92 VERSION 0.1 2015-08-01
Network Setup - Using the Remote AUI
NOTE
: Nautel recommends that the following network settings be entered/vetted by a qualified
Network Administrator. Refer to Figure 3.2.79 on page 3.2.90 for detailed descriptions of each field.
By entering the NX5’s established IP address into an Internet browser’s address bar, and then logging
into the remote AUI, you can view and edit the network parameters (see
Figure 3.2.78 on page 3.2.88 ).
You must be have remote control enabled to edit network settings using the remote AUI.
The
MAC Address
and
Status
fields are read-only; they cannot be edited.
You must select Static IP to be able to edit the
IP Address
,
Subnet Mask
,
Default Gateway
and
Nameserver
fields. If you are in DHCP mode, these fields will be assigned automatically.
The
Status
field
i
dentifies the status of the network.
 Running: transmitter is connected to a network and is functioning properly.
 Not Running: transmitter is not connected or is not functioning properly. When in this state,
remote AUI access is not possible.
Figure 3.2.80: Network Setup page
All addresses shown are
for reference purposes only