Nautel NV20LT, Руководство по установке

Страница: 57 / 78

NV20LT/NV15LT INSTALLATION MANUAL COMMISSIONING
VERSION 4.0 2018-02-26 PAGE 2.9.9
Network Setup
If you wish to remotely control the transmitter via a network or directly through a laptop, configure your
network parameters as follows:
1. Verify that the networking (DHCP on or off) decisions outlined in Section 2, “Pre-installation tasks”
of the Pre-Installation Manual have been made. To use DHCP, you must have a visible DHCP server
on your network. If you are not planning to use DHCP (i.e., your network does not have a DHCP
server), you must obtain an IP address and netmask from your network administrator as well as
gateway and nameserver(s) as applicable.
2. From the front panel UI, go the Main Menu -> User Settings -> Network Settings screen (see
Figure 2.9.6 on page 2.9.10 ).
3. Ensure your network or laptop is connected to the LAN (A1J8A) connector on the rear of the
controller (A4) or to the LAN connector (J1) on the optional remote interface PWB, if installed (see
Section 2.8, “Installing Control/Monitor Wiring” ).
4. If your network has a DHCP server and DHCP is set to ON (factory default), IP addresses will be
automatically assigned. Verify this has occurred by viewing the IP Address and Netmask address
sub-menus ( Gateway and Nameserver addresses are optional; view as applicable). The MAC
Address field cannot be modified.
5. If your network does not have a DHCP server or you wish to assign static IP addresses (i.e., direct
connection with a laptop), set DHCP to
OFF . Enter the appropriate addresses in the IP Address ,
Netmask , Gateway and Nameserver sub-menus, as applicable.
NOTE
: Refer to “Network Setup” on page 3.2.85 of the Operations and Maintenance Manual for more
information.
6. Once you have established an IP address, you can login to the NV20LT/NV15LT’s advanced user
interface (AUI), which allows you to remotely control and monitor the NV20LT/NV15LT.
See the
“Operating the Transmitter” section of the Operations and Maintenance Manual for detailed AUI
information
.