Parameter
MIDI Val-
ues
Device 1 (de-
fault)
Device 2 *
Device 3 *
Device 4 *
Hue
0–127
Channel 1
Channel 4
Channel 7
Channel 10
Saturation
0–127
Channel 2
Channel 5
Channel 8
Channel 11
Brightness
0–127
Channel 3
Channel 6
Channel 9
Channel 12
* These channels will be used when two or more units of the same type are connected to your
computer. For example, if two TRAKTOR KONTROL F1 units are connected, the unit named
“Traktor Kontrol F1 - 2” will receive HSB parameters on MIDI channels 4–6.
For more information on using two or more units of the same type simultaneously,
please refer to chapter
24, Using Two or More Units of the Same Type
Unless two or more units of the same type are connected, only channels 1–3 are used in the
table above.
Please note that updating the control elements’ colors via HSB mode at a very high rate
can lead to MIDI bus overload, making your controller temporarily unresponsive! This is
a limitation of the MIDI protocol architecture. If this happens, decrease the amount of
HSB messages sent to your controller, and consider using Indexed mode instead (see
below).
Indexed Mode
Indexed mode allows you to remotely set the color of the element’s LED via a single MIDI mes-
sage with the same type as the element. The color is derived from the MIDI value as follows:
▪
The first 2 bits of the MIDI value set the dim state of the element.
▪
The last 5 bits of the MIDI value select a particular color from a 32-color table.
Indexed mode has the avantage of using a single MIDI message (instead of three in HSB
mode) to set the element color, allowing a much lower MIDI traffic.
Reference
MIDI Message Parameters
CONTROLLER EDITOR - Manual - 319
Содержание komplete kontrol s series
Страница 1: ......