![background image](http://html.mh-extra.com/html/national-instruments/scxi-1160/scxi-1160_user-manual_3474635078.webp)
Appendix E
SCXI-1160 Cabling
© National Instruments Corporation
E-7
SCXI-1160 User Manual
Table E-4. SCXI-1160, DIO-96, AT-MIO-16D, and AT-MIO-64F-5 Pinout Equivalences
Pin
SCXI-1160 Rear Signal
Serial Connector
DIO-96
Board
Equivalent
AT-MIO-16D
AT-MIO-64F-5
24
DIG GND (MIO)
DIG GND
DIG GND
25
SERDATIN
APB3
ADIO0
ADIO0
26
SERDATOUT (MIO)
BDIO0
BDIO0
27
DAQD*/A
APB2
ADIO1
ADIO1
29
SLOT0SEL*
APB1
ADIO2
ADIO2
31
SERCLK (DIO)
APB0
37
SERCLK (MIO)
EXTSTROBE*
EXTSTROBE*
47
SERDATOUT (DIO)
APA0
50
DIG GND (DIO)
DIG GND
No other pins are connected on the SCXI-1160.
SCXI-1351 and NB5 Cable Installation
Follow these steps to install the SCXI-1351:
1. Make sure that the computer and the SCXI chassis are turned off.
2. Install the SCXI module in the chassis.
3. Connect the position 1 through 50 connector of the NB5 cable to the male breakout connector
on the SCXI-1351.
4. Plug the mounting bracket connector onto the module rear signal connector (see Figure E-2).
An alignment tab on the bracket will enter the upper board guide of the chassis.
5. Screw the mounting bracket to the threaded strips in the rear of the chassis.
6. Connect the 100-pin connector of the NB5 cable to the DIO-96 board.
After step 1, the order of these steps is not critical; however, it is easier to locate the correct
position for the mounting bracket with a module installed in the chassis. If you are attaching a
cable to the female connector, installation is easiest if you attach the second cable before
installing the SCXI-1351.