NI Wireless Sensor Network Devices
10
ni.com
Note
If your node does not connect automatically, refer
to
ni.com/info
and enter
exxhqv
for troubleshooting
information.
Step 5. Attach Sensors and Signal Lines
Attach sensors and signal lines to the terminal block or accessory
terminals for each device. For device pinouts, refer to the device
documentation.
Step 6. Start Using the NI WSN System
To use the NI WSN system, open a new LabVIEW project. If the
gateway is on the local subnet, complete the following steps:
1. Right-click the project name and select
New»Targets and
Devices
. In the Add Targets and Devices on My Project dialog
box, select
Existing target or device
and expand the
WSN Gateway
folder. When you expand the WSN Gateway
folder, the network is scanned for any connected NI WSN
gateway devices. Wait for device detection.
2. Once detected, click the NI WSN gateway device you wish to
use and click
OK
. Clicking
OK
adds the NI WSN-9791 or
NI 9792 device to the Project Explorer window.