INTELLIREAM
®
MP
pg.
15
5. Press the “LIFT” button to exit programming mode. The reaming bit will lower without spinning.
WARNING: the lift and clamp will operate under this condition. KEEP
HANDS CLEAR of the operating space of the reaming bit. This device is
intended for one-man operation during setup.
6. Spray Position: Center the nozzle approximately 25mm above the spray nozzle. Record this position as the
“Spray” position described in the programming chart above. The sprayer may use a built-in post-flow timer of 0,
¼, ½, or 1 second. Airflow from the spray nozzle will be present for the post flow time after the spray output
and corresponding fluid valve have been turned off.
Spray Position
