Naigon Electronics Igniter 3, Руководство по установке

Страница: 37 / 42

Page | 37
Aux button AUX+/- Hold Engages Saber Cinema™ for the font if one is enabled; nothing
if Saber Cinema™ is not configured for the current font
Aux/Main
button AUX+/-
MAIN+/- Hold +
Press Holding the aux button and pressing the main button within
one second will activate EzMute™.
Rotate Saber NA Rotate Rotating the saber is the new EzOn™ motion that will turn the
saber on. Note that once in low power mode the aux button
will need to be pressed before the saber can be turned on
again.
Aux button AUX+/- Hold + Point
down Holding the aux button while the saber is pointing down will
enter the Saber Apps™ menu.
6.2. RUNNING MODE
When the saber is running, there are many actions that are possible. Swings, Blaster Blocks, Clashes, Lockups and
retraction all become available. Further, this is when the main LED runs and accent LEDs follow the patterns for the
actions performed. A detailed description on how to interact with the saber is given in the following subsection.
To stop the saber from running, simply hold down the main button (unlatch if it is a latching switch) until the
retraction sound and effect occur. The saber will then return to Idle mode. From here you can re-insert the kill key
or remove the battery. Do not remove power when the saber is running, as this can cause the micro SD card to get
corrupted, and then it would need to be reformatted. Granted this is very rare but it is better to put the saber into
Idle before disconnecting the power.
6.2.1. RUNNING MODE INTERACTION TABLE
The following table lists all the interactivity that is possible with the saber while in Running mode.
Entry Label Action Description
Aux Button AUX +/- Press Pressing the aux button engages Blaster Block mode. Once in
this mode, swinging the saber will perform EzBlaster™, where
another Blaster Block will be performed. Keeping the saber
still will cause the mode to exit.
Aux Button AUX +/- Hold Taping the aux button twice is the second way to engage the
Lockup effect; the primary way is by EzLockup™ - tapping the
aux once after performing a Clash. Depending on the chosen
config setting, either releasing the button or tapping it again
will cause the mode to exit.
Aux Button AUX +/- Press (in
Clash) Pressing the AUX button will perform EzClash™; immediately
after the press the Lockup sound will play when in Clash
mode. This is the preferred way to perform a clash on
Igniter™.
Swing saber NA Swing Swinging the saber causes a single swing sound to be played.
If the swing is performed rapidly then a Slash sound will be
performed.
Rotate saber NA Rotate Rotating the saber will engage the Dual Phase™ mode of the
saber, allowing the saber to switch between colors. If Dual
Phase™ is not enabled for current font then a swing will be
played.