Page | 16
Figure 9 – Full wiring using all accent LEDs and a recharge port/kill key combo. This wiring will allow most features of Igniter 3™ to be
experienced without getting into super complex wiring. Note that the resistor/diode is needed for the red color.
3.8.
DUAL SPEAKER SETUP USING MAXAMP™
With Igniter 3™, a MaxAmp™ audio amp is integrated on the main board. However, if you want to get clear bass
sounds with a dual speaker setup, then using the MaxAmp™ in conjunction with the on-board amp allows a dual
speaker setup that will provide the best sound a saber can produce. And, since this is running two MaxAmp™ amps
at once you can be assured this would be the loudest saber setup short of using wiring the saber directly into a
receiver.
The below diagram shows the full wiring with two speakers that utilizes the low pass filter to allow only the bass
tones through to the bass speaker. This can be omitted if desired, though the best sound when using two speakers
is using this filter.
