16
17
Version C—Crimps:
Bend the headrail gently
away from the tilt mecha-
nism, and remove the tilt
mechanism, sliding it off the
end of the tilt rod (Fig. 1.7).
Slide the tilt rod out from the
barrels, removing it from the
headrail (Fig. 1.5).
6. If your blinds use strings
to tilt the slats, you may
need to remove the tassels
on the ends of the strings
in order to remove the tilt
mechanism. Untie the knot
inside of the tassels, slide
the tassels off of the string,
and set the tassels aside.
Fig. 1.7
2 Installing MySmartBlinds Hardware
1. Remove the manual switch C-clip
(C)
from the
bottom of the manual switch
(D)
by pressing
down on the clip’s center and sliding it out.
Remove the adhesive
film from the manual
switch, and insert the
manual switch through
the hole previously occu-
pied by the tilt mech-
anism, making sure
the switch is properly
oriented (Fig. 2.1).
2. Pull the hook down
through the hole so
that the switch lies flat
against the bottom
surface of the headrail
(Fig. 2.2), and press
the exposed adhesive
against the front of the
headrail.
3. Lay the blind on its side, and position the C-clip
(C)
beneath the manual switch
(D)
. Press down on
Fig. 2.2
Fig. 2.1
