Then the Internet address (IP address),
broadcast address, host name
etc. of the
driver is specified.
Now, the main menu of “netconfig” is displayed. If more
cards are to be
configured, repeat the procedure by
“add a chain” option and
driver. If no more cards are to be
quit out of “netconfig” to relink the
kernel. Specify
for the next two prompts to boot from the newly generated
kernel and to build the kernel
7.
If using 16MB or less memory on
and the
is
configured for a shared memory
of FFFOOOO, FFEOOOO or
specify the exact
at boot
as follows, at
boot prompt.
for a
system.
for a 16MB system.
This should be hard coded
in
the file
Append at the end of the
DEFBOOTSTR line, the string
or
depending
upon the amount of memory on
This completes the
installation.
90
Drivers;
Use “netconfig” command to
memory address and
of
LNE390 card. After reconfiguring, a
must bc rclinkcd and system booted. Always
make sure the memory address and
in the “nctconfig” are the same as the
one chosen in the EISA configuration.
Before removing the V 2.05
drivers, rcmovc
LNE390 chain using the
“netconfig” command. Then
USC
“custom” utility lo rcmovc all the
drivers” at
any point. After removal of drivers, kernel should bc relinkcd and system booted.
t i o n o f 9 0
Use “netconfig” to remove all the
chain, if any.
use “custom” utility to
remove LNE390 drivers, followed by installation of the LNE390 drivers. Relink the new
kernel and boot from the same.
ODT 2.0 and
ODT 3.0 have
with
and NFS with a Netware
3.11 server, Interactive Unix 3.2.3
and
ODT system.
ODT 3.0
