Ethernet IAN
Chapter 2: Hardware Installation and
Configuration
An
may be installed in any available
slot in a host system. The bask steps for
hardware installation are:
1. Install the adapter hardware in the system.
2. Connect the adapters to the
3. Configure the
using the host system’s
Configuration Utility.
This chapter
these procedures.
To use the
after the hardware Is in place,
will be necessary to install the host operating sys-
tem and the appropriate
driver. For operat-
ing system installation, refer to the
that comes with the operating system software.
The installation of
drivers is cov-
ered by subsequent chapters in this manual.
LAN
Configuration for the
Before the
can be installed In a system,
it must be
for the type of LAN you are
using. This is done by changing the settings of a
jumper block on the board, as shown in Fugure 2-1.
This operation is now required for the
Copyright 1992
3.0
