23
OPERATING THE SHOWER (CONT.)
TO DECREASE ThE TEMPERATURE
1.
Press the cooler (-) button
ONCE
. The
digit will move, for example from 6 to
5 confirmed by a single audible bleep.
The water temperature will decrease
by a nominal 1.5–2 °C. Wait a few
seconds for the shower to reduce the
temperature to the new setting.
2.
Repeat this if necessary to achieve
your ideal temperature setting waiting
each time for the new temperature to
be achieved.
FLOW CONTROL ADJUSTMENT
The push button flow control allows the
water flow through the shower to be
reduced or increased. Only occasional
adjustment will be required.
To change the flow rate press the flow
button in the appropriate place as
indicated by the LEDs (confirmed with
a single bleep). The flow will reduce or
increase (depending on the setting) and
will be indicated by the number of LEDs lit.
Please note: If the selected flow is high
and the unit cannot reach the temperature
selected the motorised flow control valve
will automatically reduce the flow to allow
the unit to reach and maintain the outlet
temperature selected. Alternatively the
medium or low flow can be chosen for
comfort and economy.
Switch the shower off by pressing the
start / stop button. A single bleep will
sound and initiate the
PhASED ShUT
DOWN
operation. The water will run for
approximately 6 seconds and then stop
taking the residual heat away from the
elements and giving a cool start up for the
next user.
IMPORTANT:
Always use the start / stop
button to switch the shower off. If the pull
cord or surface mounted isolator is used
to stop the shower without first pressing
the start / stop button then you will by
pass the phased shut down mechanism.
The seven segment display shows this
operation by counting down the horizontal
bars 3–2–1–OFF.
Finally
switch OFF at the pull cord or wall
mounted isolating switch.
ATTENTION!
DO NOT OPERATE ThE ShOWER UNIT IF ThE ShOWERhEAD
OR hOSE BECOMES DAMAGED.
ThE ShOWER IS DESIGNED AND APPROVED TO EN-60335 WITh ThE
ShOWERhEAD PROVIDED. UNDER NO CIRCUMSTANCES MUST ANy
ShOWERhEAD ThAT IS NOT APPROVED By ThE MANUFACTURER
BE USED WITh ThIS PRODUCT.
