21
COMMISSIONING THE SHOWER (CONT.)
Now press the warmer (+) button
repeatedly until the digit reaches
9 which when stable, will give a
maximum outlet temperature of
41 °C for Care models and 47 °C for
Plus models by default. If Maximum
Temperature PROGRAMME 2 has
been selected on installation this will
be 43 °C. This could take up to 30
seconds if the shower is starting from
cold. The unit will automatically adjust
the water flow if required.
The maximum temperature lock LED
will be illuminated when Maximum
Temperature PROGRAMME 1 or 2
is set.
IMPORTANT:
If the selected flow is high
and the unit cannot reach the temperature
selected the motorised flow control valve
will automatically be adjusted to allow the
unit to maintain the outlet temperature
selected. Alternatively medium or low
flow could be selected for economy and
the thermostatic unit will maintain the
temperature selected.
12.
Press the start / stop button to switch
the unit off. A single bleep will sound
and initiate the PHASED SHUT
DOWN operation.
PhASED ShUT DOWN
The Phased Shut Down operation is
activated when the shower is stopped
using the start / stop button. It switches
the heating elements OFF but allows the
water to run for approximately 6 seconds
taking the residual heat away from the
elements and giving a cool start up for the
next user.
1.
The seven segment display shows
this operation by counting down the
horizontal bars 3–2–1–OFF
2.
Switch off pull cord or wall mounted
switch
3.
Finally we recommend that the shower
head is removed to make sure no
debris has worked into it and the inlet
water filter is checked and cleaned of
any debris from the incoming pipe work.
Clean and re-fit (see section 16 for
cleaning instructions).
4.
Make sure that the water supply is fully
turned ON.
BEAB CARE INSTALLATIONS
IMPORTANT:
Additional checks and
records are required for a BEAB Care
installation. Please refer to the separate
commissioning and in-service guide for
full details.
CAUTION
Always use the start / stop button to switch the shower OFF. If the pull cord or surface
mounted isolator is used to stop the shower without first pressing the start / stop
button then you will by pass the phased shut down mechanism
!
!
!
!
