22
14. OPERATING ThE ShOWER
1.
Switch on the electrical supply at the
pull cord or wall mounted switch. The
power on
neon will illuminate indicating
the switch is on.
2.
Please do not stand under the spray
from shower handset as initially the
water will be cold. Press the shower
start /stop button for immediate water
flow. This is confirmed with a single
audible bleep.
3.
The “Secret Until Illuminated” seven
segment display will activate and show
through the front cover – displaying
the FIXED pre-programmed start up
temperature of digit 8 for Thermostatic
Care models or the MEMORY start
up temperature for the Thermostatic
Plus. The unit will indicate the start
up temperature has been reached by
sounding a DOUBLE bleep
.
4.
The shower outlet temperature will
increase until it reaches this pre-
determined temperature. This could
take up to 30 seconds if the shower is
starting from cold.
5.
The flow control will indicate the water
flow through the shower:
3x LEDs illuminated: MAXIMUM flow
2x LEDs illuminated: ECO flow
1x LED illuminated: MINIMUM flow
6.
The maximum temperature lock LED
will be illuminated when Maximum
Temperature PROGRAMME 1 or 2
is set. PROGRAMME 1 is the factory
default setting on Care models where
the maximum outlet temperature is
limited to a nominal 41 °C. This feature
is included for additional safety for use
in the care sector, less able or by the
extended family.
The LED will also be illuminated if
PROGRAMME 2 has been selected on
installation which limits the maximum
outlet temperature to a nominal 43 °C.
NOTE:
The “Secret Until Illuminated”
seven segment display indicates the
shower outlet temperature where 0 is
cold, digit 1 represents a nominal 30 °C
and digit 9 represents the maximum
temperature:
PROGRAMME 1: a nominal 41 °C
(the default setting for Care models)
PROGRAMME 2: a nominal 43 °C
PROGRAMME 3: a nominal 47 °C
(the default setting for Plus models)
7.
The shower outlet water temperature
will be controlled thermostatically during
the shower. If you wish to change this
temperature then make adjustments
described below.
TO INCREASE ThE TEMPERATURE
1.
Press the warmer (+) button
ONCE
.
The digit will move, for example from
6 to 7 confirmed by a single audible
bleep. The water temperature will
increase by a nominal 1.5–2 °C. Wait a
few seconds for the shower to increase
the temperature to the new setting.
2.
Repeat this if necessary to achieve
your ideal temperature setting waiting
each time for the new temperature to
be achieved.
NOTE:
If digit 9 is displayed by the seven
segment temperature display then it will
NOT be possible to request a higher outlet
temperature as this is limited by the PCB
control for additional safety.
