Viper TX – Operation Instructions
32
AP-75710, Rev. 1.1, 09/01/2008
Step 6 :
Draw a line, holding your pen in the same position against the adjustment plate as you did at
position 1 in step 2.
Step 7 :
Check if there is a gap between the 2 lines and do the correct action..
IF there is …
THEN …
a gap between the lines.
perform the adjustment procedure*
NO gap between the lines.
no adjustment is necessary.
* For the adjustment procedure, refer to the next topic, “Adjusting the tensioning systems”
3.5.1.2 Adjusting the tensioning systems
Introduction :
The present topic describes the adjustment of the REAR tensioning system. The procedure to adjust the
front tensioning system is the same.
Procedure :
Step 1 :
Standing at the REAR SIDE of the unit, remove the cover (1) of the adjustable bracket (3).
Tool : Hexagon wrench 2,5 mm
1 = Cover
2 = Screws
3 = Adjustable bracket
Downloaded From ManualsPrinter.com Manuals
