Viper TX – Operation Instructions
33
AP-75710, Rev. 1.1, 09/01/2008
Step 2 :
Loosen (don’t remove) the 4 screws on the side of the adjustable bracket. (See image below)
Tool : Hexagon wrench 4 mm
1 = Screws
2 = Adjustable bracket
Step 3 :
Use the 2 screws (1) in the tension bar bracket to adjust the tension system.
Tool : Hexagon
wrench 3 mm
1 = Adjustment screws
IF Line 2 lays…
THEN turn the adjustment screws as
follows :
BEFORE line 1 (Case
A
on image
above)
BEHIND line 1 (Case
B
on image
above)
Important
•
Make sure to turn both adjustment screws an equal amount of turns.
Step 4 :
Check the calibration again and repeat the adjustment until the lines overlap each other.
Downloaded From ManualsPrinter.com Manuals
