MUTOH ValueJet VJ-1604, Руководство по обслуживанию

Страница: 258 / 422

5 Self-Diagnosis Mode VJ-1604 Maintenance Manual
Rev.-00 5-60
The pump endurance running sequence is as follows.
1. Pump endurance running starts.
2. Pump phase detection is performed.
3. Rotates with the specified suction speed. This rotation is counted as one cycle.
Step 2 above is repeated the number of times specified as follows.
Super high: 4000
High: 3000
Normal: 2000
Low: 1000
4. Pump release is performed.
5. Pump endurance running ends.
5.13.4 Print Head Endurance (Nozzle Print) Menu
This menu performs endurance running for the plot head.
In the sequential plotting endurance menu you can operate sequential plotting endurance operation on the plot
head according to your desired settings.
TIP
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If
the number of cycles exceeds the maximum value, the counter is reset to 0.
Set item Contents Set value Remark
Number of endurance
running cycles Sets the number of
endurance running cycles -1 to 10000
-
Endurance Count
Performing endurance running
[Enter] key
[Enter] or [Cancel] key