Section 75
00-02-0522
04-06-11 -
38 -
iGUARD Typical Installation and Mounting
Mechanical Installation and Mounting
Please make sure that the controller was not subjected to abusive handling during shipping
and that all the components are included.
You should receive the iGUARD controller, any accessories ordered such as wire harnesses,
CT
’
s, PT
’
s, senders, and this document.
The iGUARD controller is designed to be mounted within a customer-supplied panel. It can
also be installed in an optional set-top control box, or in the
‘
doghouse
’
of an AC alternator.
When the iGUARD is used as a standalone device, it must be mounted within a protective
housing. Refer to the cutout schematic (below) for layout of the cutout and mounting screw
holes.
Once the holes are cut, check to make sure that there is adequate clearance - so that the
edges of the iGUARD housing mounts flat and flush against the outside surface of your
enclosure.
IMPORTANT
Be sure to check that there are no loose metal shavings, or other
conductive debris that may fall into or get blown into the circuit boards of
the iGUARD.
Recommended torque for tightening the mounting screws is 9-inch
pounds. Only Polycarbonate compatible thread lock should be used for
the iGUARD mounting screws.
Insert the iGUARD controller from the front side of the panel and install the four mounting
screws and lock washers. Ensure that there is a good seal between the controller, the
“
O
”
ring and the mounting panel. Plan the iGUARD mounting for easy wiring and access.
Phase-out
/ Discontinued
Product
Check
Availability