Section 75
00-02-0522
04-06-11 -
35 -
Engine
RPM
Battery
voltage
Hours
Plus a number of status bits - such as wait to start, and the lamp codes (Shutdown, warning,
maintenance).
The iGUARD displays active fault codes*. Additionally, the engine faults and severity for the
most common faults and warnings are displayed not only as the Suspect Parameter Number,
(SPN) and failure mode indication (FMI) but also in plain text.
This is intended to help with any troubleshooting.
The numeric fault codes are always available, in case the fault or warning message is not one
of the ones supported by text description.
The iGUARD will show messages in the Warnings/faults status screen. There is a J1939
screen that shows specific J1939 fault codes, status of the indicator lamps etc. This screen
only shows up when the iGUARD is set up to run from ECU data.
Note:
*
Applicable if the ECU manufacturer supports Active Fault
Phase-out
/ Discontinued
Product
Check
Availability
