Dehumidifier ML420-MLT1400
4
Installation
4.1 Safety
W
W
WARNING!
ARNING!
ARNING!
- The unit must not be splashed with or immersed in water.
- The unit must never be connected to a voltage or frequency other than that for which it was designed. Refer to the
identification plate. Line voltage that is too high can cause an electrical shock hazard and damage to the unit.
- Do not insert fingers or any objects into the air vents.
- All electrical installations must be carried out by a qualified electrician and in accordance with local regulations.
- The dehumidifier can restart automatically after a power cut. Always set and lock the main power switch in the
OFF position before carrying out any service work.
- Use only approved lifting equipment to prevent personal injury and damage to the equipment.
- Always contact Munters for service or repair.
CA
CA
CAUTION!
UTION!
UTION!
The wet air duct must always be insulated when there is a risk of freezing. Condensation builds up easily on the
inside of the duct because of the high moisture content of the wet air leaving the dehumidifier.
CA
CA
CAUTION!
UTION!
UTION!
The dehumidifier has been designed to operate at specific process airflows corresponding to the fan sizes
installed.
4.2 Site requirements
The dehumidifier is only intended for indoor installation. Avoid installing the dehumidifier in a damp
environment where there is a risk of water entering the unit or in a very dusty environment. If in doubt,
contact Munters. It is important that the intended installation site meets the location and space requirements
for the equipment in order to achieve the best possible performance.
For the unit dimensions and service space requirements, see section
9.1, Dimensions and service space
.
NOTE!
If there is a need for reduction of vibrations from the dehumidifier, contact Munters for instructions.
190TGB-1035-H1604
Installation
7
