Munch Machine Mother Bucker MB1, Руководство оператора

Страница: 20 / 24

20
Side Plate Lubrication
After a thorough cleaning of the machine, it will be necessary to lubricate the side
plates where the Take Up Bushings and Side Plates interact to insure proper movement
of the Take Up Bearings when loosening or tightening the Roller Tension System. This
grease application can be applied by a gloved hand or a small brush.
Recommended Food Safe Lubricant:
§
Lubriplate FGL-2 - product number L0232
Rollers
The Drive Roller and Follow Roller should be inspected during the cleaning process after
each use. The rollers are a wear part and will need to be replaced occasionally, and only
after significant wear is present on the rollers surface.
Proper care of the rollers starts with proper use of the Roller Tension System.
§
ATTENTION – Do not make any adjustments to the tensioning system of
the machine. The tension has been preset and will not need adjustment
unless otherwise directed by MUNCH Machine.
Coupler
The green Flex Element within the coupler assembly is a wear component that reduces
wear on the drive train components. This Nylon Cover and Flex Element should be
removed and inspected prior to high use scenarios or inspected monthly in the event of
perpetual harvest. With high wear the green Flex Element should be replaced. One
additional Flex Element is included with each machine, and additional Flex Elements can
be purchased from MUNCH Machine Customer Service. It is recommended to keep a
spare Flex Element on hand at all times.
To remove the green Flex Element, back the two screws partially out of the Black Nylon
Cover. Next, slide the Nylon Cover off, taking note of the alignment between the Nylon
Cover screws and the holes in the Flex Element. The green Flex Element can then be
removed by finding the split and then peeling the teeth out of the steel 5R Couplers. To
reinstall work backwards through these steps, being mindful of the alignment between
the Nylon Cover screws and the holes in the Flex Element.
While inspecting the Flex Element ensure that the black Nylon Cover is in good
condition. Once installed, align the Nylon Cover with the Flex Element and ensure the
screws are fully seated in the black Nylon Cover.
§
CAUTION – Do not run the machine without a complete Coupler
assembly.