Munch Machine Mother Bucker MB1, Руководство оператора

Страница: 12 / 24

12
Lift the hood keeping the 4 holes upwards and away from your body, the curvature on
the back of the hood should be the closest point to your body. Tilting the top edge of
the hood slightly forward, align the Roller Tension Bolts with the top 2 holes on the
Hood but do not set the hood down on the Force Cap. Leave about 1 inch of gap
between the Hood and Force Cap as you slowly pivot the bottom of the hood
downwards to the point where the notches on the hood and the hood mount pegs are
centered on each other. Lower the hood so that it makes contact with the pressure
plate. The two bolts should easily pass through the 2 larger holes on top of the hood,
and the notches should seat on the hood mount pegs tight against the bucking head
side plate on both the left and right side.
§
CAUTION – Supporting the hood with one hand while installing the
thumb screws is critical to prevent dropping the hood and possibly
causing injury.
Locate the 2 unused smaller holes on top of the hood, align them with the threaded
holes in the force caps, install the two thumb screws, and firmly tighten. Do not force
the thumb screws - ensure that threads are aligned properly before tightening. If you
feel any resistance, unscrew and restart. The thumb screws come pre-treated with food-
grade anti seize, which may need to be reapplied over time.
Direct Contact Surfaces
The food-grade stainless steel Faceplate and Die Plate are designed to be the only
machine surfaces in contact with product and are compatible with a cGMP compliant
workflow. Daily cleaning of these plates with the proper cleaning products (See
Cleaning) will reduce the potential for contamination of your product.
Face Plate
§
WARNING – Operation of the machine without the face plate, or with the
face plate improperly secured, will result in serious injury and possibly
death