Munch Machine Mother Bucker MB1, Руководство оператора

Страница: 17 / 24

17
Solid panels or rigid mesh panels may also be used and can be placed closer to the
machine depending on the mesh opening size (US companies should refer to OSHA
regulations). Consult with your local work place safety officials to ensure you meet your
relevant regulations.
o
WARNING – Operation of equipment without the proper guarding installed
could result in serious injury and possibly death
Contact MUNCH Machine Customer Service if you need further assistance.
Machine Operation
Daily Inspection
o
Check that the hood is installed properly
o
Die plate is clean and free of debris.
o
Rollers are clean and free of debris.
o
Drive System and Coupler are in good condition and installed properly.
o
Ensure all electrical components are in good working order
o
Ensure all machine components are secure and in good working order.
Start Up
o
Tighten Rollers using the provided 5/16” hex key to tighten the two button head
bolts located on top of the hood until fully seated.
o
Ensure the Power Selector Switch is in the “OFF” position
o
Ensure the Emergency Stop button is in the “UP” position.
o
Plug the machine in to a circuit having sufficient current capacity and correct
voltage.
o
Adjust Variable Speed Control to desired speed - if unknown then start slow and
work your way up in speed paying close attention to the quality of the bucked
material.
o
Place Catchment System (bin, bucket, bag, conveyor, etc.) in position to receive
material.
o
Turn on the machine by rotating Power Selector Switch clockwise to the “FWD”
position.
Operation
o
Feed material into the Die Plate holes, attempting to select a Die Plate hole that
matches the stem size.
o
In the case of a product jam, rotate Power Selector Switch counter clockwise to
“REV” to reverse the rollers until the jam is cleared, then release and rotate
Power Selector Switch back to “FWD” and continue feeding material.