Multitech MultiVOIP 200, Руководство пользователя

Страница: 25 / 97

25
Chapter 3 - Software Loading and Configuration
11 In the Ethernet group, enter the IP Address, Subnet Mask, and Gateway Address, unique to
your IP LAN, in the corresponding fields.
The IP address is your unique LAN IP address, and the Gateway address is the IP address of
the device connecting your MultiVOIP to the Internet.
Click OK when you are finished.
12 The Channel Setup dialog box is displayed. Its three tabs are used to define the voice/fax
channel interface, voice coder, fax parameters, and regional phone parameters (tone pairs)
for each channel.
Configure each channel for the type of interface you are connecting to. The Interface tab
defaults to Channel 1 in the Select Channel field. To change the channel number, click the
drop-down arrow and the list of channels is displayed. Highlight the channel you want to
configure.
13 The Interface group defaults to FXS (Loop Start). Select the interface option that corre-
sponds to the interface type being connected to the Voice/Fax Channel 1 jack on the back
panel of the MultiVOIP.
If you are connected to a station device; e.g., an analog telephone, fax machine, or KTS
telephone system to the Voice/Fax connector on the back of the unit, FXS (Loop Start) will
likely be the correct Interface option.
If the station device uses ground start, then choose the FXS (Ground Start) option. Refer to
the device’s user documentation.
If you are using an analog extension from your PBX, then choose the FXO option. Check with
your in-house phone personnel to verify the connection type.
If you are connecting to an analog E&M trunk on your PBX, then choose the E&M option.
If you choose the FXO interface, the Dialing Options Regeneration group is enabled. Check
with your local in-house phone personnel to verify whether your local PBX dial signaling is
Pulse or tone (DTMF). Then, set the Regeneration option accordingly.