9
Indicators
:
Liquid Crystal Display (LCD)
: The two-line LCD on the front panel of the Smart Tracker serves as the main visual
communications device and enables the user to view a number of operational parameters of the Smart Tracker at any
given time. Parameters automatically scroll over the LCD. A description of the menu tree may be found in the
Startup and Operation
section of this manual.
LEDs
: At the lower right hand corner of each outlet is a red LED that is used to indicate active power to that
respective outlet. Each relay and input contact on the back of the Smart Tracker also contains a red LED to indicate
active relays or input contacts. These LEDs are placed between the two contacts of each relay or input contact.
Section 4:
Installation
and
Setup
Installation of the Smart Tracker into a rack system or enclosure may be accomplished by attaching the unit to the
standard 19-inch rack and connecting the wiring to the appropriate connectors of the Smart Tracker. All power
connections on the front of the Smart Tracker can be made using 5-15R mating equipment. On the rear panel of the Smart
Tracker, each of the terminal plugs uses bare copper wiring. Moreover, connections used in this Smart Tracker mate with
accessory harnesses and assemblies designed and manufactured by Multilink Inc. Refer to the
OPTIONS
section of these
instructions for further information.
In all installations, the following conditions apply and must be observed:
A service disconnect switch containing over-current protection devices such as circuit breakers or fuses with
appropriate AIC (amperes – interrupting capacity) rating should be placed between the AC utility source and the
service entrance device for the Smart Tracker. Where used, the disconnect switch must be installed in compliance
with all national, state, and local codes as required.
For outdoor installations, the AC utility conductors connected to the Smart Tracker service entrance device shall
be physically protected through an appropriate restraining device and conduit, consistent with local codes and
practices.
Permission to mount the Smart Tracker enclosure at any site shall be made in accordance with all legal
requirements and local practices of the area.
This Smart Tracker is designed for use in a variety of rack systems and enclosures. Observe the following procedures
during installation of any Smart Tracker.
Preparation
:
The Smart Tracker has been factory assembled, tested, and prepared as a complete product ready for installation
within a rack system or enclosure. The installer must verify that the correct type of AC power receptacle is installed in
the enclosure for the input service and Smart Tracker selected for use at any given site.
Grounding
:
Safety ground and earth ground connections must be in place for the Smart Tracker and enclosure for both personal
safety and operational considerations. During Smart Tracker and/or enclosure installation, the following grounding
connections must be provided or verified.
CAUTION
Failure to provide and connect adequate safety and earth grounds at each installation site may result in
improper Smart Tracker operation or permanent damage to the Smart Tracker itself. Grounding facilities
and connections must conform to appropriate national codes and/or local practices.
