46
Configure Static and DHCP IP Addressing
:
The user may change the network configuration to a static IP address by selecting the “Static” radio button and filling
in the three textboxes. The gray addresses in the textboxes are used to show valid formats for each textbox. The user
may also press and hold the “Enter” button from the front panel for 10 seconds to set the factory default IP address.
Note
: Take care to verify that the static IP address chosen is not currently in use and the appropriate subnet mask and
gateway are configured for the IP address selected. The example below shows the factory default IP address, subnet
mask, and gateway for the Smart Tracker.
Click the “Save and Reboot” button to store the changes and allow the Smart Tracker to reboot. Once the unit restarts,
the user may address the unit through the new static IP address. The user may also change the Static IP address to
DHCP by selecting the DHCP radio button and clicking “Save and Reboot”. The network configuration will be auto-
matically assigned to the Smart Tracker.
