MuL Technologies 3 Series, Руководство пользователя

Страница: 18 / 44

18
Programming your first destinations
Now that you ’ re ready to roll, let’s give MARC a try!
1. If cart is booted up and ready, go to step 5.
2. Turn the key switch to ON position.
3. Press power button. If the cart does not power up, verify the emergency stop button is not engaged and
disengage if needed (rotate clockwise with arrows until it pops out).
4. Wait for MARC to boot up, approximately 2-3 minutes.
• Cart is ready when audio cue “Cart ready” is heard and indicator LEDs are pulsing green.
5. Using the handle, manually push the cart to the first location you want to program as a destination.
•
Wherever MARC is physically located will be the destination when a button is programmed.
•
Speed between locations can be a normal walking speed (up to 1.3 m/second or 3MPH) or less.
•
Start and end points should be a minimum of 1m (3 feet) from all stationary objects.
•
Entire route should include 6 feet of available space.
6. Press and hold any un-programmed station key (grey) for 3 seconds until you hear the double-beep sound.
• In this example, we used “3.” Station button will turn green, indicating programming completed.
7. Using the handle, manually push the cart to a second location you wish to program as a destination.
8. Press and hold any un-programmed station key (grey) for 3 seconds until you hear the double-beep sound.
• Use any unused station key 1-13 (in this example, we used “1”).
That’s it! You have programmed MARC for 2 destinations in Active Map Mode and can put him to work. Press the station
button for each programmed key (in our example 1 and 3), and MARC will travel to the location programmed for that
button.
Additional tips:
• In Active Map Mode, MARC does not retain information when powered down or restarted.
• This section describes Active Map Mode. You can also use MARC in Fixed Map Mode if you plan to use MARC in
a specific area. See Operating modes: Active and Fixed on page 21 for more information.
• You can add a new destination at any time using any additional un-programmed station button.
• MARC will prioritize the path you took when programming destinations.
• You can re- program any station button by moving the cart to a new destination and pressing a pre-programmed
button (green) for 3 seconds and the current location replaces the previous destination.
• You can also remove a destination from a button without programming a new one. Hold the programmed
button (green) 6 seconds until you hear a triple-beep. The button will turn grey and will not be associated with a
destination.
•
In Active Mapping Mode, you can also move your MARC system to any additional, non-programmed locations
(for example, to get inventory items from shelves), and then tap one of the pre-programmed buttons to send
MARC back to that location.
For detailed information on using the EZ-Go Navigation panel, see Premium (15-button) EZ-Go Navigation system
overview on page 19 or Value (6-button) EZ-Go Navigation system overview on page 21 .
TIP: If you see the second screen, press
the battery level button to return to the
first screen with station buttons.
TIP: Your MARC system may have a 6-
button navigation system (Value model).
Programming operation is the same.