MSH equipment WIZARD UP 30, Руководство по эксплуатации

Страница: 16 / 42

Wizard Up30 Rev. 4 28/04/2017
15
6. INSTALLATION
THE LIFT IS FOR INDOOR USAGE ONLY.
UNPACK THE GOODS AND CHECK FOR POSSIBLE DAMAGE BEFORE INSTALLING THE LIFT.
ONLY SKILLED TECHNICIANS, APPOINTED BY THE MANUFACTURER, OR BY AUTHORIZED DEALERS
SHOULD BE ALLOWED TO INSTALL THE CAR LIFT. SERIOUS DAMAGE TO PEOPLE OR EQUIPMENT CAN
BE CAUSED IF THIS RULE IS NOT FOLLOWED AND IN ANY CASE THE MANUFACTURER IS EXEMPT
FROM RESPONSIBILITY.
The lift must be installed according to the specified safe distance from walls, columns, other equipments etc. The
room must be a minimum 4500 mm. in height. The minimum distance from walls must be 1500 mm. take into
consideration the necessary space to work easily. Further space for the control site and for possible runways in case
of emergency is also necessary. (
pic. 8 ).
INSTALLATION PROCEDURE
1. Lift location.
2. Check for power supply availability.
3. Hydraulic connections.
4. Electric network connection.
5. Concrete base and lift fixing.
6. Initial running.
LIFT LOCATION
Pic. 8
Place the automotive lift using a crane truck or any other lifting equipment in the desired position. Raise (to open the
lift) the two platforms using a crane, following the instructions in the
pic.8 , and place them at a height of about 50 cm.
Insert a wooden shim to prevent the lift from closing during the slinging phase. To move the car lift, sling it as
described in pic.8 and place it into the right position. Use metal shims to level the ground where necessary.
CHECK FOR POWER SUPPLY AVAILABILITY
The room must be previously arranged for the power supply of the lift. Make sure that supplies are not far from the
power unit.
P1
P2
Min.
1500
Max
2000
Min
800
H 4500 min