MSH equipment WIZARD UP 30, Руководство по эксплуатации

Страница: 14 / 42

Wizard Up30 Rev. 4 28/04/2017
13
5. SAFETY
GENERAL RULES
Read this chapter carefully it contains important information concerning the safety of the operator. The operator and
the maintenance personnel are required to observe the accident prevention legislation in force in the country of
installation of the lift
Pic. 7
1. Operating the lift only by authorized person
2. During lifting or lowering operations, the lift must be operated only from the operator area as shown in the
diagram (pic. 7) .
3. Standing or passing within the danger area when the lift is working or the vehicle is raised is strictly
forbidden.
4. The operator must make sure the hazard area is clear when lifting or lowering the lift.
5. Never use the lift without protection or when safety devices are off-line.
6. Always use the rubber pads when lifting a vehicle, observing the proper points of support specified by the
vehicle’s manufacturer.
7. Switch off the engine and engage the parking brake after placing the vehicle on the car lift; Furthermore,
disengage the gear lever and move it to the “neutral” position.
8. To prevent the vehicle from falling make sure it is properly placed on the lift.
9. Getting in or on the vehicle and-or starting the engine when the car lift is raised is strictly forbidden.
10. Never leave objects and-or obstructions under the vehicle or scattered on it during the lowering phase.
11. Keep the area under/next to the lift clear and remove possible oil spots to avoid the risk of slipping.
12. Never use water-steam-varnish-solvent jets in the lift area, and particularly, close to the control box.
13. Proper lighting is extremely important. Make sure all areas next to the car lift are well and uniformly lie,
according to that specified by the applicable laws of the place of installation.
14. Climbing on the platforms or under the platforms when lifting the vehicle or when the same has been
already raised is strictly forbidden.
15. Any use of the lift other than what herein specified can cause serious accidents to the operator as well as
to the people in close proximity.
16. The tampering of safety devices is strictly forbidden.
17. Never exceed the maximum lifting capacity. Make sure the vehicles to be raised are without loads.
18. In case of anomaly, stop the car lift and block the on/off selector by using a padlock. Only skilled
technicians should be allowed to restart the lift. Be sure the power supply is off before repairing and
servicing the lift. The operator, the lift or the vehicles raised can be seriously damaged if these instruction
are not followed.
19. Respect the complete operating instruction, in particular in case of anomalies.