MAINTENANCE MS TOPCOAT
M4 MANUAL POWDER GUN
Cleaning and changing nozzles
Interruption of work
If work is interrupted, the powder gun should be blown
through and cleaned of residual powder.
Sequence advances:
1. Turn off controller.
2. Pull out the powder injector from injector connection,
so that no more powder can be conveyed.
3. Hold the powder gun in the spray enclosure and clean
with compressed air the powder gun of powder.
3
4
1
2
2
3
4
1
2
NOZZLE CHANGE
Removing the nozzle
1. Clean the powder gun as described above in Interruption
of work
2. Pull of nozzle (1) from the nozzle tube (3).
WA R N I N G
!
Wear parts in the powder gun, marked with a W
in the spare parts list, must be checked regularly and
replaced if necessary.
CAUTION
!
Maintenance, repair or replacement of parts may
only be performed by trained personnel of MS Powder.
CAUTION
!
For maintenance and cleaning work the controller
must always be switched off at the main switch.
3. Unscrew the nozzle nut (2) from the gun body (4).
PA-18-02-R0 (08/2018)
48 / 52
www.carlisleft.com
EN
INSTALLATION
