ASSIGNMENT OF KEYS
Bottom menu programs
Switch to the Programs
Bottom cleaning
Start cleaning up for press again
Standard program
The default is two standard programs.
• Program Standard surface part (ONE LAYER)
• Program secondary coating (TWO LAYER)
Bottom On Off
Setting the high voltage
With this, the high voltage of the gun can be adjusted.
Depending on the powder charging is set between 40 kV
to 80 kV. Standard powder can be set with approximately
70 kV Metallic powders are set about 50 - 60 kV.
Setting the current control
The current regulation has a great influence on the charge on
the powder. As a rule, little electricity is used. Approximately
20 µA. In weakly chargeable powder, the amount of current
must set higher. In case of over coating or MDF coating, the
amount of current can be set low. Approximately 8-10 µA.
ELECTRICAL SETTINGS
NOTE
In case of excessive amount of electricity
produced orange peel.
0
10
20
30
60
70
100
40 50
80
90
kV
+
–
70
0
10
20
30
60
70
100
40 50
80
90
µA
+
–
10
PROGRAMS
CLEANING
ONE LAYER
TWO LAYER
OFF ON
PA-18-02-R0 (08/2018)
29 / 52
www.carlisleft.com
EN
MAINTENAMCE
