Basic Operation Modes:
AUTO/COOL/DRY/HEAT (Model Dependent)
OTHER FEATURES
NOTE: A guide on using the infrared remote is not
included. Not all of the functions listed below are
available on your unit. Please check the indoor
display and remote control of the unit you have
purchased.
Auto-Restart (some units)
If the unit loses power, such as during a power outage,
it will automatically restart with the prior settings once
the power has been restored.
Anti-Mildew (some units)
When the unit is turned off, while in
COOL
,
AUTO
(COOL)
,
or
DRY
mode, it will continue to operate
at very low power to dry up condensed water and
prevent the growth of mildew.
Active Clean function (some units)
The Active Clean Technology is designed to wash
away dust that has accumulated to the heat
exchanger. It does this by automatically freezing to
create frost, and then rapidly thawing it. This process
will create more condensed water which will make the
cleaning process more effective. The fan will blow the
cold air produced out. Once the cleaning process has
completed, the internal fan will then circulate hot air
through the system to blow-dry the evaporator, thus
keeping the inside of the unit clean. Some noises may
be heard from the unit during this process. These
are normal.
When this function is activated the indoor unit
display will show “
CL
,
” after 20 to 130 minutes,
the unit will turn off automatically and cancel the
Active Clean function.
For some units, the system will start the
high-temperature cleaning process. The
temperature of the air exiting the air outlet will be
very high. Please keep away from it, as it could
cause injury. This may also cause the temperature
of the room to rise, until operation is complete.
Wireless Control (some units)
Wireless control allows you to control the unit from
your mobile phone and a wireless connection. For
USB device access, replacement or maintenance
operations must be performed by qualified staff.
Page 16
mrcool.com
Installation Summary - Indoor Unit
4
Indoor Unit Installation
Installation Summary - Indoor Unit
Select Installation
Location
Attach Mounting
Plate
Determine Wall
Hole Position
2
3
Drill Wall Hole
Mount Indoor Unit
to Mounting Plate
Wrap Piping and Cable
(not applicable for some locations in the US )
Connect Piping
Prepare Drain Hose
4
5
6
7
8
1
4.75 in
(12 cm)
90.55 in
(2.3 m)
4.75 in
(12 cm)
5.9 in (15 cm)
Connect Wiring to Outdoor Unit
(once installed)
9
