Page 21
mrcool.com
Indoor Unit Installation
Installation Instructions –
Outdoor Unit
Step 1: Selecting an installation location
choose an appropriate location. Use the following
guidelines to help you select an appropriate
location.
P
following guidelines:
Meets all spatial requirements shown in
)
Good air circulation and ventilation
the unit and will not cause vibration
Noise from the unit will not disturb others
Protected from prolonged periods of
exposure to direct sunlight or rain
DO NOT
install unit in the following locations:
Near an obstacle that will block air inlets and
outlets
Near a public street, crowded areas, or where
noise from the unit will disturb others
Near animals or plants that will be harmed
by hot air discharge
Near any source of combustible gas
In a location that is exposed to large amounts
of dust
In a location exposed to a excessive
amounts of salty air
In a location that exposes the unit to large
amounts of forced water
Fig. 5.1
5
Outdoor Unit Installation
24in (60cm)
above
24in (60cm)
on right
Minimum Clearance
above unit:
24 in (60cm)
12in (30cm)
on left
Minimum Clearance
on the left side of
unit: 12 in (30 cm)
Minimum Clearance
on the right side of
the unit: 24 in
(60 cm)
Minimum Clearance
in front of the unit:
79 in (200 cm)
Minimum Clearance
between the back of
the unit and wall:
12 in (30 cm)
Where snowfall is anticipated, raise the unit
above the base pad to prevent ice buildup
and coil damage. Mount the unit in a position
high enough to be above the average
accumulated area snowfall. The minimum
height must be at least 18 in (457.2 mm).
NOTE: Install the unit by following local codes and
regulations. These may differ slightly depending
on the region where the unit is being installed.
