Outdoor Unit (Exterior / Condenser)
Refrigerant Piping
Drainage Pipe
Wrap piping & connections
from indoor unit upward to
exterior wall hole
Fast Connect
®
connections
Sound Deadening Pads to
wrap connections once
connected and checked for
leaks.
BEFORE PERFORMING ELECTRICAL WORK, READ THESE REGULATIONS
All wiring must comply with local and national electrical codes.
2.
All electrical connections must be made according to the
Electrical Connection Diagram
located on
the panels of both the indoor and outdoor units.
3.
If there is a serious safety issue with the power supply, stop work immediately. Explain your reasoning
to the client, and refuse to install the unit until the safety issue is properly resolved.
4.
5.
6.
7.
Only connect the unit to an individual branch circuit outlet. Do not connect another appliance to the
same circuit as the unit.
8.
Make sure to properly ground the unit.
9.
Do not allow wires to touch or rest against the refrigerant tubing, compressor, or any other moving
part within the unit.
combustible materials.
Page 33
mrcool.com
Refrigerant Piping Connection
1.
10.
11.
To avoid getting an electric shock, never touch the electrical components right after the power supply has
been turned off. After turning off the power, always wait at least 10 minutes before you touch the
electrical components.
12.
If connecting power to fixed wiring, a surge protector and main power switch should be installed.
wrap from
bottom to top
to ensure tape
overlap, as it
will shed water
coil then wrap
bundled excess
