MQ Power WHISPERWATT DCA300SSJU4F2, Руководство по эксплуатации

Страница: 43 / 74

DCA300SSJU4F2 60 HZ GENERATOR• OPERATION MANUAL — REV. #0 (06/26/18) — PAGE 43
STARTING (AUTO MODE)
DANGER
Before connecting this generator to any
building’s electrical system, a
licensed
electrician must install an isolation
(transfer) switch. Serious damage to
the building’s electrical system may occur
without this transfer switch.
CAUTION
When connecting the generator to a isolation (transfer)
switch, ALWAYS have power applied to the generator’s
internal battery charger. This will ensure that the engine
will not fail due to a dead battery.
NOTICE
When the generator is set in the AUTO mode, the
generator will
automatically start
in the event of
commercial power falling below a prescribed level
by means of a contact closure that is generated
automatically by a transfer switch.
WARNING
When running the generator in the
AUTO
mode,
remember the generator can start up at any time without
warning.
NEVER
attempt to perform any maintenance
when the generator is in the auto mode.
When starting generator in
AUTO
mode use the “Manual
Start-up” procedure except where noted (see below).
1. Perform steps 1 through 5 in the Before Starting section
as outlined in the Manual Starting Procedure.
2. Place the
Auto Off/Reset Manual Switch
(Figure 55)
in the
AUTO
position.
Figure 55.
Auto Off/Reset Manual
Sw itch (AUTO)
3. Continue operating the generator as outlined in the
Manual Start-up procedure (start at step 2).
NOTICE
When the
Auto Off/Reset Manual Switch
is placed
in the AUTO position, the engine glow plugs will be
warmed and the engine will start automatically.
NOTICE
If the unit has
Power Balance
™ installed and once
the main breaker is closed, the
Power Balance
™
should activate after 1 minute if the load is below 30%
of rated load.
If at any time the load spikes to 90% or more, the Power
Balance will immediately drop out and wait 5 minutes
to re-evaluate the load.
GENERATOR START-UP PROCEDURE (AUTO MODE)