MQ Power WHISPERWATT DCA300SSJU4F2, Руководство по эксплуатации

Страница: 42 / 74

PAGE 42 — DCA300SSJU4F2 60 HZ GENERATOR • OPERATION MANUAL — REV. #0 (06/26/18)
5. If the voltage is not within the specified tolerance, use
the voltage adjustment control knob (Figure 49) to
increase or decrease the desired voltage.
Figure 49. Voltage Adjust Control Knob
6. The ammeter (Figure 50) will indicate zero amps with
no load applied. When a load is applied, the ammeter
will indicate the amount of current that the load is
drawing from the generator.
Figure 50. Ammeter (No Load)
7. The
engine oil pressure gauge
(Figure 51
A
) will
indicate the oil pressure of the engine. Under normal
operating conditions the oil pressure is approximately
35 to 65 psi. (193~586 kPa).
Figure 51. Engine Gauges
8. The
coolant temperature gauge
(Figure 51
B
) will
indicate the coolant temperature. Under normal
operating conditions the coolant temperature should
be between 185°~207°F (85°~97°C).
9. The tachometer gauge (Figure 51 C ) will indicate the
speed of the engine when the generator is operating.
Under normal operating conditions this speed is
approximately 1800 RPM’s.
PSI
OIL PRESS
0
25
50
75
100
°F
WATER TEMP
100
140
180
220
260
A B
RPMX10
SPEED
0
120
150
180
210
60
C
10. The generator load gauge (Figure 52) Indicates the
generator load rate. It is recommended the load be
above the red area (20%) for maintaining sufficient
exhaust temperature.
Figure 52. Generator Load Gauge
11. Place the
main, GFCI, and aux.
circuit breakers in the
ON position (Figure 53).
Figure 53. Main, Aux. and GFCI
Circuit Breakers (ON)
12. Observe the generator’s ammeter (Figure 54) and
verify it reads the anticipated amount of current with
respect to the load. The ammeter will only display a
current reading if a load is in use.
Figure 54. Ammeter (Load)
13. The generator will run until manually stopped or an
abnormal condition occurs.
%
0
50
100
GENERATOR START-UP PROCEDURE (MANUAL)