MP Systems AK CB20, Инструкция по установке, эксплуатации и обслуживанию

Страница: 34 / 81

28 MPSYSTEMS-M-001/06
7. Operation
A few steps must be taken before MP SYSTEMS auxiliary coolant and chip control system
can be put into operation.
7.1. Filling & Priming
1. Fill machine tool coolant tank with coolant/cutting fluid;
2. Fill tank of R Series with coolant/cutting fluid;

Fill to just below opening of return.

Be sure to use same coolant/cutting fluid being used in machine tool tank.
3. Remove side panel of unit;

Labeled with ‘ MP SYSTEMS ’, opposite coolant tank.

Allows access to supply pump for priming.
4. Open wye valves on top of machine;
5. Open prime valve for supply pump;

Located in main cabinet of unit.

Upper right hand side of unit.

Allow time for coolant to fill supply pump. Supply pump is fully primed once inlet hose
has become filled will coolant/cutting fluid.
6. Once supply pump/Inlet hose have been filled with fluid, close prime valve;
7. Power the machine ‘ON’;
8. Press the float arm, present in machine tank, to activate supply pump;

Ensure fan on rear of pump rotates clockwise.
9. Press the float arm, present in tank, to activate supply pump, to fully prime;

Lower float for a few seconds, release and repeat as needed.
Supply pump may need to be run multiple times to pull full prime. Reset alarm on PLC,
using the

key to allow unit to run, if necessary.
Prime Valve
Float Arm
Side Panel