MOZELT GmbH & Co. KG
Load lifting magnet devices
Technical manual:
CoolGen 4
Copyright:
MOZELT GmbH & Co. KG, D-47269 Duisburg
Edition:
August 2014
Rev.:
00
Page 2
English
2. Usage to the Intended Purpose
Synchronous generators with integrated electronics are
components for installation in machines which are used
in industrial plants.
Start-up of the power generators is not allowed before
it has been verified that the machine in which the
generators are installed conforms to the Machinery
Directive.
The generators conform to the protection goals of the
low-voltage directive.
Operation is only allowed when the EMC Directive is
adhered to.
The technical data and information about connection
conditions are given in the nameplate and documentation
and shall be adhered to by all means.
3. Transport, Storage
The instructions for transport, storage and proper
handling are to be observed.
Defects detected after delivery shall be reported
immediately to the carrier. Before start-up, the supplier is
to be notified, if necessary.
4. Installation
The installation and cooling of the devices must be
carried out according to the provisions of the respective
documentation.
The generators are to be protected against inadmissible
loads. They are only to be touched in such a way that no
components are bent and/or insulation clearances are
changed. Avoid touching the electronic elements and
contacts.
1. General
During use the generator may have live, bare, if
applicable, also hot surfaces. In the case of inadmissible
removal of the required cover, inappropriate use, wrong
installation or operation, there is the risk of death or
severe injury or material damage.
All work concerning the transport, installation and start-
up as well as maintenance are to be carried out by
qualified technical personnel (IEC 364 and/or CENELEC
HD 384 or DIN VDE 0100 and IEC Report 664 or DIN VDE
0110 and national regulation for accident prevention or
VGB 4 are to be observed).
Qualified technical personnel according to these basic
safety references are persons who are familiar with the
installation, assembly, start-up and operation of the
product and possess corresponding qualifications for
their activity (defined in IEC 364 or DIN
VDE 0105).
For reasons of safety and the preservation of
documented system data and functions, repairs to the
generator or its components may only be undertaken by
the manufacturer.
Technical data, as well as data concerning connection
conditions, are to be taken from the rating plate and the
documentation and are to be strictly observed.
Safety information / General information
All passages provided with the „warning“ sign in the manual contain information
important for avoiding danger!
WARNING
All passages provided with the „caution“ sign in the manual contain information
necessary for avoiding damage to the power supply or accessories!
CAUTION
It is absolutely necessary to observe the
following warnings.
If these warnings are not observed,
serious personal injuries with fatal result,
severe injuries to health or considerable
damage to property cannot be ruled out!
WARNING
