Moxa Technologies NPort 6000 Series, Руководство пользователя

Страница: 69 / 178

NPort 6000 Series Module Settings
6-12
Dial-out number: Use this field to configure the number that the user uses to dial out.
Dial-in number: Use this field to configure the number that the user uses only to dial in.
Initial string: Use this field to configure the initial string that the modem will use to establish the connection.
Connection control Connect Rule Disconnect Rule GSM
Always on/None Always on after power on None Trunk
Periodically
connect/inactivity time Periodically connect (based on the
setting of connection interval ) to GSM
after power on. Inactivity time is up Trunk
Remote host fail/remote
host recovered Remote Ethernet host has failed. The
NPort 6000 will keep pinging the
remote host over the Ethernet every 3
seconds after powering on. After failing
to connect 5 times in a row, the data
from the serial device will be sent
through the GSM connection. When the remote
Ethernet host returns to
normal, data will revert
to being sent over
Ethernet after 5
continuous successful
pings. Backup
Connection interval (default= 5 min): The time interval of Periodically connect function.
Ping remote host: Key in the IP address or Domain name of the remote host.
GPRS Operation Mode
TCP/IP compression (default=Disable): The setting of this field depends on whether or not the remote
user’s application requests compression.
Inactivity time (default=0 ms): This field specifies the idle time setting for auto-disconnection. A setting of
0 ms will cause the port to remain connected even if idle.
Link quality report (default=Disable): Setting this field to Enable allows the NPort 6000 to disconnect a
connection if the link noise exceeds a certain threshold.
Username: This is the user ID account.
Password: This is the user password.
APN: Before using the GPRS, the APN (Access Point Name) must be added as a modem initialization command.
Detailed instructions are shown below.
Initial string: Use this field to configure the initial string that the modem will use to establish the connection.