Motorola Netopia 7000, Руководство администратора

Страница: 259 / 368

259
set igmp wireless-m2u [ on | off ]
This command allows you enable or disable wireless multicast-to-unicast if igmp snooping is set to on .
set igmp log-enable [ on | off ]
If set to
on
, all IGMP messages on both the LAN and the WAN will be logged. Default is
off
.
IP Settings
You can use the command line inter face to specify whether TCP/IP is enabled, identify a default Gateway,
and to enter TCP/IP settings for the Motorola Netopia® Gateway LAN and WAN por ts.
☛
NOTE:
For the DSL platform you must identify the vir tual PPP inter face [ vccn ], a number from 1 to 8.
Common Settings
set ip option { on | off }
Enables or disables TCP/IP ser vices in the Motorola Netopia® Gateway. You must enable TCP/IP ser vices
before you can enter other TCP/IP settings for the Motorola Netopia® Gateway. If you turn off TCP/IP ser-
vices and save the new configuration, the Motorola Netopia® Gateway clears its TCP/IP settings.
ARP Timeout Settings
set ip arp-timeout [ 60 ... 6000 ]
Sets the timeout value for ARP timeout. Default = 600 secs (10 mins); range = 60 secs - 6000 secs (1–
100 mins).
DSL Settings
set ip dsl vccn address
ip_address
Assigns an IP address to the vir tual circuit. Enter 0.0.0.0 if you want the vir tual circuit to obtain its IP
address from a remote DHCP ser ver.
set ip dsl vccn broadcast
broadcast_address
Specifies the broadcast address for the TCP/IP network connected to the vir tual circuit. IP hosts use the
broadcast address to send messages to ever y host on your network simultaneously.
The broadcast address for most networks is the network number followed by 255. For example, the broad-
cast address for the 192.168.1.0 network would be 192.168.1.255.