Motorola Netopia 7000, Руководство администратора

Страница: 257 / 368

257
IGMP Settings
NOTE: IGMP Version 3 is suppor ted beginning with Firmware Version 7.7.
See “IGMP (Internet Group Management Protocol)” on page 100 for detailed explanation.
You can set the following options:
•
IGMP Snooping – enables the Motorola Netopia® Gateway to “listen in” to IGMP traffic. The Gateway
discovers multicast group membership for the purpose of restricting multicast transmissions to only
those por ts which have requested them. This helps to reduce overall network traffic from streaming
media and other bandwidth-intensive IP multicast applications.
• Robustness
– a way of indicating how sensitive to lost packets the network is. IGMP can recover from
robustness minus 1 lost IGMP packet. The default value is 2.
•
Query Interval – the amount of time in seconds between IGMP General Quer y messages sent by the
querier gateway. The default quer y inter val is 125 seconds.
• Query Response Interval
– the maximum amount of time in tenths of a second that the IGMP router
waits to receive a response to a General Quer y message. The default quer y response inter val is 10 sec-
onds and must be less than the quer y inter val.
•
Unsolicited Report Interval – the amount of time in seconds between repetitions of a par ticular com-
puter’s initial repor t of membership in a group. The default unsolicited repor t inter val is 10 seconds.
• Querier Version
– select a version of the IGMP Querier: version 1 , version 2 , or version 3 . If you know
you will be communicating with other hosts that are limited to v1 or v2, for backward compatibility, select
accordingly; other wise, allow the default v3.
☛
NOTE:
IGMP Querier version is relevant only if the router is configured for IGMP for warding. If any
IGMP v1 routers are present on the subnet, the querier
must use IGMP v1. The use of IGMP v1
must be administratively configured, since there is no reliable way of dynamically determining
whether IGMP v1 routers are present on a network. IGMP for warding is enabled per IP Profile
and WAN Connection Profile.
• Last Member Query Interval
– the amount of time in tenths of a second that the IGMP gateway waits
to receive a response to a Group-Specific Quer y message. The last member quer y inter val is also the
amount of time in seconds between successive Group-Specific Quer y messages. The default last mem-
ber quer y inter val is 1 second (10 deci-seconds).
•
Last Member Query Count – the number of Group-Specific Quer y messages sent before the gateway
assumes that there are no members of the host group being queried on this inter face. The default last
member quer y count is 2.
• Fast Leave
– set to
off
by default, fast leave enables a non-standard expedited leave mechanism. The
querier keeps track of which client is requesting which channel by IP address. When a leave message is
received, the querier can check its internal table to see if there are any more clients on this group. If
there are none, it immediately sends an IGMP leave message to the upstream querier.
•
Log Enable – If set to on, all IGMP messages on both the LAN and the WAN will be logged.
• Wireless Multicast to Unicast conversion
– Only available if
IGMP Snooping
is enabled. If set to
on
,
the Gateway replaces the multicast MAC-address with the physical MAC-address of the wireless client. If
there is more than one wireless client interested in the same multicast group, the router will rever t to
multicasting the stream immediately. When one or more wireless clients leave a group, and the router