Motorola DCP501 - DVD Player / AV Receiver, Руководство по установке

Страница: 151 / 188

D-6 Diagnostics
DCP501 Installation Manual
Table D-3 lists the error codes:
Table D-3
Error codes
Initialization status errors
Error Code OSD Cause Remedy
E 00* NO ERROR Indicates normal condition after
initialization Not applicable
E 01* NOT CONNECTED DCP501 did not receive a connect
message
Send a connect message
Restore out-of-band signal
E 02
PWR CYCLE Init Error Box needs a Power Cycle
to recover
E 03 DRAM DRAM error Not used at this time
E 04 DPSRAM DP-SRAM error Not used at this time
E 07
ROM ROM verification failure Power cycle box; if
repetitive, return for repair
E 08 RAM Faulty RAM, ROM, EEPROM, or
POST failure (this is a hardware
failure) Return DCP501 for repair
E 09 BATTERY Dead battery or memory has not been
initialized; occurs if battery fails to
keep the RAM alive during
power-down; causes DCP501 to be
disconnected Return DCP501 for repair;
requires factory
initialization message
E 10
SERIALNO Invalid serial number Not used at this time
E 11
UNIT ADDRESS Invalid unit address Return DCP501 for repair;
requires a unit creation
message
E 12
POST POST failed Not used at this time
E 13
BOOT Sys_boot initialization failure Power cycle box; if
repetitive, return for repair
E 14
STARTUP DCP501 system startup failure Power cycle box; if
repetitive, return for repair
E 15 TSI INVALID TSI structure is corrupted Power cycle box; if
repetitive, return for repair
E 16
FLASH BAD
NUMBER Bad flash number specified for Initiate
Flash Platform Error logged, ignore
E 17 BAD PLATVAL Bad platform validation step number Error logged, ignore
*E 00 and E 01 cannot be displayed while the DCP501 is off. The other errors will display on the LED
display when the DCP501 is off.